Die elastic deformation in hot forging by rigid-plastic finite element method : AFDEX

Die structural analysisDie elastic deformation in hot forging by rigid-plastic finite element method

Rigid die

Elastic die

The figures compares the predictions of an axi-symmetric hot forging process between with and without considerations of die elastic deformation. The process does not allow any flash, that is, it is a flashless closed-die forging process.

Of course, grain flows of them are very close to each other. However, forming loads at the final stroke is quite different. Elastic deformation of die reduced the predicted forming load by almost 30%, compared with the rigid-die case. This is one of the reasons that predicted forming loads are considerably greater than the actual forming loads especially in closed-die forging without flash.

Simulation considering die deformation Die elastic deformation in cold forging

List New post

Forging

Conventional forging

Do you have any questions
about metal forming simulations?
Partner with AFDEX.

Forging

Conventional forging

Do you have any questions about metal forming simulations?Partner with AFDEX.

Do you have any questions
about metal forming simulations?
Partner with AFDEX.